Compliance With Bs6328 Part 1 - Multitech MultiModem MT5634ZPW-PCI Owner's Manual

Owner's Manual
Compliance with BS6789: Section 3.1 and
Part 2
a. The modem is not capable of allowing Auto Call using '999'
or other PABX emergency numbers.
b. Modes other than modes 1, 2, or 3 should not be used on
the BT PSTN. This modem is a mode 1 device.
c. Users are advised to check the numbers entered during the
Auto Call set up phase prior to dialing.
d. The user should not issue any sequence of commands to
the modem which would cause the modem to exceed the
maximum allowable pause of 8 seconds from the time the
modem goes off hook until dialing begins.
e. For correct operation of the call progress monitor, the power
has to be properly connected and switched on.

Compliance with BS6328 Part 1

a. The modem is not suitable for use on circuits with British
Telecommunications signaling at a normal frequency of
2280 Hz.
b. The modem does not require signaling or otherwise employ
the frequency range dc to 200 Hz.
c. The modem does not require dc from the Private Circuit for
correct operation. The modem may be damaged if
connected, in a private circuit mode, to a circuit supplying dc
current (the maximum permissible direct current is zero
amps).
86
MT5634ZPW-PCI