Multitech MultiModem MT5634ZPW-PCI Owner's Manual page 46

Owner's Manual
\N n
Command:
Values:
Default:
Description: \N0
\N1
\N2
\N3
\N4
\N5
\N7
Command: \Q n
Values:
Default:
Description: \Q0
\Q1
\Q2
\Q3
Command: \T n
Values:
Default:
Description: \Tn
\V n
Command:
Values:
Default:
Description: \V0
\V1
Command: \X n
Values:
Defaults:
Description: \X0
\X1
46
Error Correction Mode Selection
n = 0–5, or 7
3
Non-error correction mode with data buffering (same
as &Q6 ).
Direct mode.
MNP reliable mode.
V.42/MNP auto-reliable mode.
V.42 reliable mode.
V.42, MNP, or non-error correction (same as \N3 ).
V.42, MNP, or non-error correction (same as \N3 ).
Local Flow Control Selection
n = 0, 1, or 3
3
Disable flow control (same as &K0 ).
XON/XOFF software flow control (same as &K4 ).
CTS-only flow control. Not supported—responds
ERROR.
RTS/CTS hardware flow control (same as &K3 ).
Inactivity Timer
n = 0–255
n/a
Inactivity timer setting contingent on either \T value or
S-Register S30 value (e.g., AT\T45&W0<cr>
configures in parallel ATS30=45&W0<cr>), and vice
versa.
Protocol Result Code
n = 0 or 1
1
Disable protocol result code appended to DCE speed.
Enable protocol result code appended to DCE speed.
XON/XOFF Pass-Through
n = 0 or 1
0
Respond to and discard XON/XOFF characters.
Not supported—responds ERROR.
MT5634ZPW-PCI