Channel Switch; Ptz Control Panel - Avtech AVC799B User Manual

3.2.1 Channel Switch

Click on the quick menu bar to display the panel as follows:

3.2.2 PTZ Control Panel

Note: In the PTZ control mode, hot point is supported to move the camera view to the specified point
after a click.
Click on the quick menu bar to display the panel as follows:
/ / /
/
/
/
/
Video Channel
1~16
Number
Sequence
Display
Quad Display
9-Cut Display
16-Cut Display
Click to enter the camera main menu.
Camera Menu
For details about each camera menu, please refer to its own user manual.
Enter Click to confirm your selection / enter the menu.
Up / Down / Left / Right Click to move your selection up / down / left / right, or change settings.
This two buttons are designed for the PTZ camera which uses Pelco-D to
Iris + / Iris - control. To know the actions after clicking Iris + and Iris -, please refer to
the camera's user manual.
Click to zoom in on the image to the largest / zoom out on the image to its
Zoom in / out max
original size.
Zoom in / out Click to zoom in / out the image.
Focus near / far Click to adjust the focus of the image.
Click to activate the auto function.
Before using it, you need to assign a specific function that will be enabled
Auto mode
when "AUTO" is clicked. For details, please refer to the user manual of the
PTZ camera.
Preset point Click to enter the PTZ preset point you want to see.
GUI DISPLAY WITH USB MOUSE CONTROL
Click to switch to the channel you want in full screen.
Click to display each channel in full screen one by one starting
from CH1. When the last channel is displayed, it will repeat from
CH1 again.
When this function is on,
Press to show the 4-channel display mode.
Press to show the 9-channel display mode.
Press to show the 16-channel display mode.
10
will be shown on the status bar.