Clear Hard Disk; Password Setting - Avtech AVC799B User Manual

Note: For the first time to use the DVR, please power it on for at least 48 hours continuously after the
date & time is set correctly. It helps to prevent DVR time from resetting after the disconnecting of
DVR power. If the DVR time resets after the disconnecting of DVR power, for example, caused by
a power outage, the battery might run out and please replace the battery as described in
"APPENDIX 6 DVR BATTERY REPLACEMENT" at page 65.
Right-click to enter the DVR password with the password keypad. The default administrator password is 0000.
The status will be changed from
and select "QUICK START"
GENERAL
TIME SETUP
EXIT

2.5 Clear Hard Disk

It's recommended to clear all data in the hard disk for the first time to use this DVR to ensure the recorded data are
not mixed with other data previously saved in the same hard disk.
Right-click to show the main menu, and select "SYSTEM"
reboot when HDD data are cleared. For details, please refer to "5.3.2 SYSTEM INFO" at page 19.
TOOLS
SYSTEM INFO
BACKUP DATA (USB)
BACKUP LOG (USB)
EXIT

2.6 Password Setting

Right-click to show the main menu, and select "SYSTEM"
There are two user levels: ADMIN & OPERATOR. For details, please refer to "5.3.1 TOOLS" at page 18.
TOOLS
SYSTEM INFO
BACKUP DATA (USB)
BACKUP LOG (USB)
EXIT
(key lock) to
"TIME SETUP" to set the date & time.
QUICK START
DATE 2009 / NOV / 17
TIME 15 : 35 : 53
SYSTEM
BAUD RATE
HOST ID
R.E.T.R
AUTO KEY LOCK
CLEAR HDD
RESET DEFAULT
REMOTE CONTROL ID
SERIAL TYPE
VIDEO FORMAT
VERSION
SYSTEM
LANGUAGE
ADMIN PASSWORD
OPERATOR PASSWORD
UPGRADE
BACKUP CONFIG
RESTORE CONFIG
(administrator). Then, right-click to show the main menu,
"SYSTEM INFO"
2400
000
5
NEVER
HDD-0
SUBMIT
000
RS485
NTSC
1019-1008-1010-1010
"TOOLS" to change the DVR password.
ENGLISH
SETUP
SETUP
SUBMIT
SUBMIT
SUBMIT
8
CONNECTION AND SETUP
"CLEAR HDD". The DVR will