Setting Channels - Vello Freewave Aviator User Manual

SETTING CHANNELS

Setting an Aviator
Transceiver's Channel
To set the desired Channel,
do the following:
1. From the TTL Screen or the Slave Mode
screen, press Menu to enter Channel
Select.
2. Use the + and − buttons to select the
desired channel from 1-16 (channels
5-16 are only available when using two
Aviator Transceiver units).
3. Press Select to apply the setting.
Note: all devices must be set to the same channel for the system to function properly.
16
Setting an Aviator Receiver's Channel
While the Receiver is Off, slide the Channel
switch to the desired Channel (1, 2, 3
or Auto). Then turn the Receiver on.
Note: "Auto" is equal to the
Transceiver's Channel "4"
Channel