Setting The Channel; Setting The Channel On The Receiver - Vello shutterboss User Manual

SETTING THE CHANNEL

Setting the Channel on the
Transmitter: The transmitter and
receiver must be set to the same channel
for proper communication.
1: Use the arrow button to select the channel
setting. Press the left and right
arrows until CH is displayed in the
upper right corner of the screen.
2: Press the center button on the arrow
button to change the setting.
3: Press the up and down arrows to adjust
the channel up or down.
4: Press the center button to lock the setting.

Setting the Channel on the Receiver:

1: With the device on, press the CH– and
CH+ at the same time. The CH in the
display will blink, indicating that you can
now change the setting.
2: Press the CH– or CH+ buttons to
adjust the channel.
3: Press both CH– and CH+ buttons a
second time to save your setting. If no
action is taken in ten seconds, the device
will save the setting displayed.
8
The channels you select for the transmitter
and receiver will become the default
settings for the next time you power up the
device.
When you select [––] as the channel for the
transmitter and receiver, this effectively
sets the devices to communicate on all
channels. A receiver set to [––] will
respond to any transmission it receives on
the 2.4GHz frequency. This is useful in
setups with multiple devices all needing to
respond to a single trigger.