TROUBLESHOOTING
• Check the contact between the light's
hot shoe foot and the Receiver's hot
shoe, and between the camera's hot
shoe and the Transceiver's hot-shoe
foot.
• Make sure the hot-shoe light's locking
switch is set to the lock position.
• Make sure that the Receiver is powered
on and at the correct setting.
• Remove the batteries from the
Transceiver and Receiver, wait a moment
and then replace.
• Change the channel by adjusting the
switch on the Receiver and the setting
on the Transceiver to a different
combination, taking care to ensure that
both the Transceiver and Receiver are
set identically.
• Ensure that your TTL compatible flash is
set to TTL mode, even when using the
Transceiver to trigger in manual mode.
• After changing settings on the Aviator
Transceiver, push the /Test button to
confirm new settings.
FCC COMPLIANCE
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.
31