CHANGING A FLASH GROUP'S POWER MODE
Set a Flash Group to Manual mode
Using a Transceiver in Master mode:
1. Set your compatible TTL hot-shoe flash
to TTL mode.
2. From the Transceiver's TTL Screen,
press the Select button, and the screen
will begin to blink.
3. Press the desired group button (A, B,
or C) twice to set that group to manual
mode.
4. Use the + and − buttons to adjust the
manual power setting.
24
5. Press Select twice when done to apply
the settings.
6. Press /Test to confirm settings.
Manual Flash Mode
Power Setting
Turn a Flash Group Off
Using a Transceiver in Master mode:
1. Press the desired group button (A, B, or
C) to toggle through the power modes
until you reach Off.
2. Press /Test to confirm settings.
Flash Group
set to Off