ADJUSTING A FLASH GROUP'S TTL POWER (EV)
Using a Transceiver in Master mode:
1. From the TTL Screen, press Select. The
screen will start flashing.
2. Press A, B, or C to select the desired
flash group. The selected group will
start flashing.
3. Use the + and − buttons to set the EV
(exposure) in TTL mode.
4. Press Select twice when done to apply
the settings.
5. Press /Test to confirm settings.
20
Note: /Test fires a test flash on all
connected hot-shoe lights and studio lights.
It is advisable to always test fire your flashes
after making changes to confirm your settings.
TTL EV
Setting