Using Studio Flashes With A Receiver Or Transceiver - Vello Freewave Aviator User Manual

USING STUDIO FLASHES WITH A RECEIVER OR TRANSCEIVER

For more complex lighting needs, the
FreeWave Aviator can also trigger studio
flashes independently or alongside hot-shoe
flashes. (Note that TTL compatibility is
only available for TTL-capable flashes.)
Both the Aviator Receiver and Transceiver
have 3.5 mm Sync Ports, and the Receiver
also has a PC Sync Port which allows you to
connect a sync cable to your studio flashes.
Note: the PC Sync Port will also
accept a PC locking cable.
14
Connecting with a 3.5 mm Cable
1. Plug the 3.5 mm cable into the Receiver
or Transceiver's Sync Port.
2. Plug the other end of the cable into the
studio flash's 3.5 mm jack.
3. If your studio flash has a 1/4˝ monoplug
jack, you will need to use the included
3.5 mm to 1/4˝ monoplug cable.
Connecting with a PC Sync Cable
1. Using a PC Sync to 3.5 mm cable (not
included), plug the PC Sync end into the
Receiver's PC Sync port.
2. Plug the 3.5 mm end of the cable into
the studio flash's 3.5 mm jack.
3. If your studio flash has a 1/4˝ monoplug
jack, you will need to use a PC Sync to
1/4˝ monoplug cable (not included).