Message Transfer (Only Tiptel 331); General Information - TIPTEL 330 Operating Instructions Manual

Message transfer (only tiptel 331)

General information

In the answering mode with message transfer on, the answering machine dials the pre-pro-
grammed target number after each or after every 2nd, 3rd, 4th or 5th incoming message (see
message collection) has been recorded. When the handset of the programmed target number is
picked up, the following announcement is heard:
"Automatic call, X messages, please perform a remote interrogation. I repeat ...",
or if you also programmed your own telephone number as identification:
" Automatic call, telephone number ... (own telephone number), x messages, please perform
remote interrogation. I repeat ..."
During the announcement, there is the option to start the remote interrogation of the recorded
incoming message(s). Apart from the message transfer to normal telephone numbers, your tip-
tel offers you the option to program various paging service numbers. For pager numbers, this
automatic announcement will not be played back. If the target telephone number is busy, the
device will redial the number up to three times every 3 minutes. If a remote interrogation is not
performed within 20 minutes, the answering machine will call the target telephone number again
as a reminder. This procedure will be repeated twice if no remote interrogation is performed.
Remark:
It is not possible to use the message transfer function if the remote code is 0000.
The following programming is necessary for the message transfer:
Target telephone number:
The target telephone number is the number your tiptel 331 dials for the message transfer. If a
normal target telephone number is programmed, your tiptel 331 informs you if one or more cal-
lers left you a message. Your tiptel 331 will also inform you about incoming messages if a pager
number was programmed as the target number. For identification purposes, please enter the
pager symbol " 0" at the end of the entered target number.
After selecting the paging service, it is possible to enter numeric information which is transferred
to your pager during the message transfer.
Pager procedure:
(Offers you the option to program an own access procedure when you select the pager service
with the pager symbol " 0".)
25