Answering Mode On/Off - TIPTEL 330 Operating Instructions Manual

Telephone answering mode
In the telephone answering mode, your tiptel 330/331 answers incoming calls. It picks up after
the programmed number of ringing tones. When the answering mode is on, the LED indicator
lights up or blinks at short intervals (if the LED indicator blinks at short intervals you have new
and not yet played back messages).
The number of calls can be taken from the two digits on the right. The number of recorded inco-
ming messages can be taken from the two digits on the left.

Answering mode on/off

Be sure that there is sufficient recording capacity available.
If necessary, you can erase individual or all older incoming messages.
Be sure that your outgoing message is complete. The pre-recorded OGM is automatically sel-
ected for the initial operation as this is the factory pre-set. Thus, it can be used immediately.
1. Press the
2. Press to switch
the answering mode
off.
18
button. The LED indicator lights up and
the recording time is informed by
a synthesised voice. The coun-
ter for the number of incoming
recordings and calls is displayed
when outgoing message "with"
incoming recording was selec-
ted, e. g. 02:03. This means that
there have been 2 incoming
messages and 3 calls during
your absence. You may screen
incoming calls. By picking up the
handset you can take over the
call personally. The LED indica-
tor blinks if incoming messages
have been recorded. "AO"
(announcement only) is display-
ed if you selected outgoing mes-
sage "without" incoming recor-
ding. The number of calls can
be taken from the two digits on
the right. If there are incoming
recordings not played back or
information was recorded,
the display shows the num-
ber of calls not yet played
back instead of "AO"!
Further calls will not be answe-
red up by the answering machi-
ne. The display shows the time
again. The LED indicator will
blink as long as the recorded
messages have not been play-
ed back.