Table of Contents
Advertisement
Factory pre-set / programmable parameters
You can determine the following programmable parameters:
Maximum recording time:
Number of ringing tones:
Remote control code:
Remote erase:
Room monitoring:
Date
Weekday
Time
Before switching on, the device must be in the factory pre-set mode (answer mode off).
If required, press the STOP button.
Here you can program the maximum recording time
placed at disposal for the recording of the caller's inco-
ming message: 1, 2, 3, 4, 5 minutes or endless.
Indicates after how many ringing tones the answering
machine will pick up: 1 – 8 ringing tones as well as 1 –
4 and 1 – 6 ringing tones. Only when 1 – 4 or 1 – 6 rin
ging tones are programmed, a remote incoming mes
sage interrogation is possible. This means that the
answering machine picks up only after 4 or 6 ringing
tones if no new incoming messages have been recor-
ded. If new messages exist the device picks up after
just one ringing tone.
The remote control code is a 4-digit number between
0001 and 9999.
The remote control operation is switched off if code
number 0000 is programmed.
Yes/no (see remote operation)
Yes/no (see remote operation)
1.
Press
and
simultaneously
and hold for 2 seconds.
2.
Set desired recording
time by the buttons
or
.
3.
Press
.
4.
Select number of rin-
ging tones by the but
tons
or
.
5.
Press
.
6.
Select remote control
code by the buttons
or
.
Press
.
16
The display blinks and the cur-
rent recording time is
displayed.
The display shows "1, 2, 3, 4,
5 min" or "ENDL".
The last entry is programmed.
The display shows the pro-
grammed number of ringing
tones.
The display shows "1 ton", "8
ton" as well as "1_ _ 4" and
"1_ _6".
The last displayed number of
ringing tones is programmed.
The display shows the pro-
grammed remote control code,
e. g. "1234".
The display counts up or down
from 0000 to 9999. With 0000
the remote control operation is
off.
The last displayed remote con-
trol code is programmed.
Advertisement
Table of Contents
