Message Transfer; Setting The Destination Number - TIPTEL 333 Operating Instructions Manual

Message transfer

Message transfer
In the answering mode with activated message transfer, your tiptel
333 dials a pre-programmed destination phone number after a new
message has been recorded. When the handset of the programmed
destination number is picked up, the following announcement will be
heard:
"Automatic call, ... please perform a remote interrogation. ...
I repeat, ...automatic call, ... please perform a remote interrogation.
... The unit disconnects now. Good bye."
During the announcement, there is the option to start the remote
interrogation of the recorded message(s). If the destination number
is busy, the device will redial the number up to three times every
three minutes.

Setting the destination number

Please enter the destination number as described in the chapter
"Settings".
For telephone systems, the following special characters are
available:
P = 3 seconds pause / wait for dialling tone
i = internal (within telephone systems)
F = flash (short, 90 ms)
H = hook-flash (long, 240 ms)
If you use a telephone system, the exchange identification code is
automatically dialled before each telephone number (see chapter
"Settings / Exchange identification code"). In order to avoid this for
internal extension numbers, you need to dial "i" before any internal
destination number.
21