Message Transfer; Setting The Destination Number - TIPTEL 332 CLIP Operating Instructions Manual

Message transfer

In the answering mode with message transfer on, your tiptel 332 CLIP dials a pre-
programmed destination phone number after an incoming message has been
recorded. When the handset of the programmed destination number is picked up,
the following announcement is heard:
"Automatic call, ... please perform a remote interrogation. ... I repeat, ...automatic
call, ... please perform a remote interrogation. ... The unit disconnects now. Good
bye."
During the announcement, there is the option to start the remote interrogation of the
recorded incoming message(s). If the destination number is busy, the device will
redial the number up to three times every three minutes.

Setting the destination number

Please enter the destination number as described in the chapter "Settings".
For telephone systems, the following special characters are available:
P = 3 seconds pause / wait for dialling tone
i = internal (within telephone systems)
F = flash (short, 90 ms)
H = hook-flash (long, 240 ms)
In the case of telephone systems, the exchange identification code is automatically
dialled before each telephone number (see chapter "Settings / Exchange
identification code"). In order to avoid this for internal extension numbers, you need
to dial "i" before any internal destination number.
Examples:
subscriber's main station
normal subscriber
mobile phone
telephone systems
from extension to extension
to the public exchange
to the public exchange
Message transfer
(exchange identification code has been set)
(no exchange identification code has been set)
02102123456
01701234567
i 269
02102123456
0 P 02102123456
22