How To Operate The Remote Control - TIPTEL 330 Operating Instructions Manual

Remote beeper
G
ROOM MONITORING. The microphone of the answering machine switches on and you
hear what is happening in the surroundings (can be useful for telephone babysitting or
acoustic operation control of machinery).
G
ROOM SPEAKING. The speaker of the answering machine switches on. Persons
present in the room can listen to you.
G
REMOTE CHANGE of outgoing messages.
G
REMOTE CHANGE of the telephone number for the message transfer (only tiptel 331).
G
REMOTE EXCHANGE of selected outgoing message.
G
REMOTE ON/OFF of the telephone answering mode.
G
REMOTE ON/OFF of the time control mode.
G
MESSAGE CODE which allows privileged callers to leave a message although the machine
might be in the announcement mode only.
G
VIP CODE for privileged callers who want you to take over the call personally if you are present.
G
ROOM SIGNAL. The loudspeaker emits a signal in order to inform people present that
they should take over the call personally.

How to operate the remote control

1. Switch remote beeper on.
2. Call your answering machine and wait until you hear the OGM.
3. Hold the remote beeper against the mouthpiece of the handset.
4. Enter the remote control code. The remote control code can be sent during the OGM or while
one of the following incoming recordings are played back.
Attention: A remote operation is not possible if the remote control code is 0000.
When entering the code, please press and hold each key for approx. 1 second. Make a pause
of approx. 1 second after entering each number. If the answering machine identified the cor-
rect remote control code you will hear the announcement informing you about the number of
incoming recordings. Please re-enter the remote control code if no such announcement is
made. If an incorrect remote control code is entered three times, the answering machine swit-
ches off.
5. Wait for the announcement. Select the desired remote control function. Your answering machi-
ne gives a voice confirmation for nearly all of the available functions. Also errors are indica-
ted by voice message.
6. Conclude your remote operation by pressing the buttons ❋ and # (consecutively).
Remark:
If you conclude the operation by replacing the handset it may take up to 180 seconds before your
tiptel 330/331 returns to the answering mode.
To make sure that you are still on the line, your telephone answering
machine emits a confirmation request if no button was pressed during the
remote operation for about 180 seconds.
You must answer this confirmation request by pressing any button of the
remote beeper. Otherwise, the answering machine will disconnect the line
and resume the answering mode.
The remote operation tones can be entered either with a remote beeper or
a tone dialling telephone.
32