Selecting The Monitor/Group - Sony Trinitron BVM-A32E1WU Operation Manual

Selecting the Monitor/Group

When the multiple monitors are connected by the network
connections, you can connect the monitors from the control
unit by designating the monitor ID No. or group ID No..
About monitor ID No. and group ID No.
The BKM-15R Monitor Control Unit is able to control the
multiplex monitors connected via the LAN (10/100)
connector. By giving each monitor a monitor ID No. and
About monitor select buttons and lamps
PHASE
UP MENU
DOWN ENTER
MANUAL
Pin number Function
1 UP button Increases the ID No..
1 DOWN button Decreases the ID No..
2 MENU button In setting mode, goes back
to the previous setting.
3 ENTER button Confirms the setting.
4 Lamps The lamp corresponding with
the pressed button blinks
during setting ID No. or lights
after confirming.
5 Display window Selected monitor ID No.,
group ID No. or ALL is
displayed. The display
blinks until the remote
connection is completed.
1 UP/DOWN button
2 MENU button
3 ENTER button
CHROMA BRIGHT CONTRAST
MANUAL MANUAL MANUAL
group ID No., it is possible to control just a specific
monitor or monitor group.
With the NETWORK menu, each monitor can be set with
a monitor ID No. or group ID No., between 1 and 99.
The monitor select buttons are used to select a particular
monitor or group by entering a monitor ID No. or group ID
No..
For the network menu, see "
SYSTEM CONFIGURATION Menu" on page 43.
4 Lamps
5 Display window
REMOTE
SINGLE
1
GROUP
4
ALL
SINGLE GROUP ALL
7
6 SINGLE button
7 GROUP button
8 ALL button
9 Numeric buttons
q; Ent button
qa Del button
Pin number
6 SINGLE button
7 GROUP button
8 ALL button
9 Numeric buttons
q; Ent button
qa Del button
[D]
System Configuration –
INPUT
2 3 Del
6 0
5
8 9 Ent
Function
Selects SINGLE connection
mode.
The monitor ID number is
displayed on all connected
monitors when the button is
held pressed.
Selects GROUP connection
mode.
The group ID number is
displayed on all connected
monitors when the button is
held pressed.
Selects ALL connection
mode.
Enters the ID No..
Confirms the setting.
Deletes the ID No..
Selecting the Monitor/Group
23