Table of Contents
Advertisement
The cursor moves in the
direction of the arrow
corresponding to the
1
2
3
pressed button.
4
5
6
7
8
9
LUMINANCE: PHASE KNOB (Adjust the phase
with the PHASE knob.)
[E311] MANUAL ADJUST menu
Adjust the gain at the cursor position using the
CONTRAST (RED), BRIGHT (GREEN), CHROMA
(BLUE) and PHASE (LUMINANCE) knobs. Move the
cursor using the numeric keypad.
To reset RED/GREEN/BLUE to the value before
adjustment
When you are adjusting the gain using the MANUAL
adjustment knobs, you can reset the setting to the one
before adjustment by pressing the corresponding
MANUAL button.
To cancel adjustment
Press the MENU button. The adjusted data is cleared and
the screen returns to [E31]. (It may take some time to
change to the previous menu.)
To confirm adjustment
Press the ENTER (Ent) button.
When you want to erase characters from the
screen while adjusting manually
Press the CHAR OFF button. The characters disappear. To
display characters, press the CHAR OFF button again.
[E32] AUTO FULL POINTS ADJ menu
Automatically adjust the whole area of the screen in
sequence using the Sony BKM-14L Auto Setup Probe.
Before entering the AUTO FULL POINTS ADJ menu,
connect the BKM-14L to the OPTION connector.
The following message appears. (It may take some time to
change to the next menu.)
SET PROBE ON CURSOR
To perform adjustment, operate the BKM-14L as follows:
1 Place the BKM-14L on the cursor displayed in the
center of the screen. The adjustment starts. When the
adjustment is completed, the cursor is displayed at the
next adjustment point.
2 Move the BKM-14L to the cursor. The next
adjustment is performed.
In the same way, adjust each adjustment point guided by
the cursor. When the adjustment of all points is completed,
the screen automatically returns to the INSTALLATION
SETTINGS menu.
To cancel adjustment
Press the MENU button. The adjusted data is cleared and
the screen returns to the DIGITAL UNIFORMITY ADJ...
menu. (It may take some time to change to the previous
menu.)
If the BKM-14L is not placed on the cursor
The following message appears, and the cursor moves to
the right and left alternately on the screen.
DO YOU WISH TO CANCEL?
CANCEL: LEFT CURSOR
CONTINUE: RIGHT CURSOR
To abort, place the BKM-14L on the cursor when it is
displayed on the left. Returns to the DIGITAL
UNIFORMITY ADJ... menu.
To continue, place the BKM-14L on the cursor when it is
displayed on the right. Returns to AUTO FULL POINTS
ADJ menu.
[E33] AUTO ONE POINT ADJ menu
Automatically adjust only the selected adjustment point of
the screen using the Sony BKM-14L Auto Setup Probe.
Before entering the AUTO ONE POINT ADJ menu,
connect the BKM-14L to the OPTION connector.
The cursor flashes in the center of the screen.
Knobs and buttons used for each adjustment
CURSOR POSITION: 10KEY: Move the cursor
using the numeric keypad (except the 5 button).
Turn the cursor ON/OFF using the 5 button.
TO CANCEL: MENU KEY: Press the MENU button
to clear the adjusted data and return to the previous
menu.
TO CONFIRM: ENTER KEY: Press the ENTER or
Ent button to confirm the adjusted data.
To perform adjustment, operate the BKM-14L as follows:
1 Move the cursor to the desired point using the numeric
keypad (except the 5 button), and press the ENTER or
Ent button. The following message appears and the
cursor returns to the center.
SET PROBE ON CURSOR
Page 51
- Quick Links:
- Table of Contents
- English
- Features
- Specifications
Hide quick links:
Advertisement
Chapters
Table of Contents
