Sony Trinitron BVM-A32E1WU Operation Manual page 119

H STATIC CONV: Adjust horizontal static
convergence on the whole screen.
CONV FINE ADJUST...: Adjust the convergence finely
at each adjustment point on the screen. k[E21]
RESTORE FACTORY DATA: Reset the
ALIGNMENT data of the monitored signal system,
aspect and scan size to the default setting. The
following message appears to confirm the data reset
operation.
RESTORE FACTORY DATA?
OK: Press the ENTER or Ent button to reset the
data.
CANCEL: Press the MENU button to cancel the
reset operation.
[E21] CONV FINE ADJUST... menu
Adjust the convergence finely at each adjustment point on
the screen with the MANUAL knobs.
The signal system, aspect and scan size for the adjustment
are displayed on the top of the screen.
MANUAL ADJUST: Adjust the convergence.
k[E211] (It may take some time to change to the
next menu.)
RESTORE FACTORY DATA: Reset the
CONVERGENCE FINE data of the monitored
signal system, aspect and scan size to the default
setting.
The following message appears to confirm the data
reset operation.
RESTORE FACTORY DATA?
OK: Press the ENTER or Ent button to reset the
data.
CANCEL: Press the MENU button to cancel the
reset operation.
Appropriate knobs and buttons used in each
adjustment
H CONV: CONTRAST KNOB: Adjust the
horizontal convergence with the CONTRAST
knob.
H G CONV: BRIGHT KNOB: Adjust the horizontal
convergence with the BRIGHT knob.
V CONV: CHROMA KNOB: Adjust the vertical
convergence with the CHROMA knob.
V G CONV: PHASE KNOB: Adjust the vertical
convergence with the PHASE knob.
CURSOR POSITION: 10KEY: Move the cursor
using the numeric keypad (except the 5 button) as
illustrated below. Turn on/off the cursor using the 5
button.
The cursor moves in
the direction of the
arrow corresponding to
the pressed button.
TO CANCEL: MENU KEY: Press the MENU
button to clear the adjusted data and return to the
previous menu.
TO CONFIRM: ENTER KEY: Press the
ENTER or Ent button to confirm the adjusted
data.
[E211] MANUAL ADJUST menu
Adjust the convergence at the cursor position using the
CONTRAST (H CONV), BRIGHT (H G CONV),
CHROMA (V CONV) and PHASE (V G CONV) knobs.
Move the cursor using the numeric keypad.
BVM-A32E1WU/A32E1WM
H CONV: Turn the CONTRAST knob clockwise to
move the R beam to the right and the B beam to the
left; counterclockwise to move the R beam to the
left and the B beam to the right.
Turn
counterclockwise.
R
R G B G
B
BVM-A32E1WA
H CONV: Turn the CONTRAST knob clockwise to
move the B beam to the right and the R beam to the
left; counterclockwise to move the B beam to the
left and the R beam to the right.
Turn
counterclockwise.
R
G
B G R
B
[E] Installation Settings – INSTALLATION SETTINGS Menu
1
2 3
4 6
5
7 8 9
Turn clockwise.
B G R
Turn clockwise.
R G B
49