Installing A Decoder Adaptor - Sony Trinitron BVM-A32E1WU Operation Manual

Installing a Decoder Adaptor

Each decoder adaptor can be installed in any input option
slot on the rear panel.
Note
Turn off the main power of the monitor and disconnect the
AC power cord before installing or removing adaptors.
1
Remove the cover of an input option slot on the rear
panel of the monitor.
Cover of an input option slot
Make sure the MAIN POWER switch is
turned OFF, and disconnect the AC power
cord.
2
Insert the adaptor under the positioning mark on the
top of the slot (on the left of the screw hole).
Positioning mark
Insert the adaptor
here.
10
Overview
3
Push the adaptor in until it is firmly seated in the
connector inside the monitor, then tighten the two
screws to secure the adaptor.
Notes
• The left side of the cover is equipped with shielded
projections. Handle the cover carefully so as not to
damage them.
• When the removed cover is reattached, check the up/
down side of the cover. The shielded projections should
face the left side.
Position the shielded
projections so that they face
the left side.
• If the shielded projections are damaged or the cover is
attached in the wrong direction, the monitor may not
conform to the radiation standards.