Fujitsu Primergy RX100 S2 User Manual page 234

Chapter 9 Operation and Maintenance
■ Event Log Errors after Installation
After Windows Server 2003 or Windows 2000 Server has been installed, the following events may be
displayed in Event Viewer. Check and perform the corrective action against the relevant event.
ID
9 The device ****, did not respond
during the timeout time.
15 The device, ****, is not ready for
access yet.
62 This computer is a domain PDC at the
root of forest. Use the net command
"net time /setsntp:<server name>" to
configure it for synchronization from
an external time source.
1000 The user or computer name cannot be
identified. The return value is "1722."
234
table: Error events at installation
Description
This message may appear when an expansion card such as a
RAID card or a SCSI card is installed. However, this is not a
problem.
Cause:
An NTP was selected as a component.
Corrective action:
ServerStart cannot configure the NTP server automatically due
to the absence of items for specifying it. After OS installation,
perform the following procedure to specify the time server.
Cause:
The primary DNS server address may be invalid or the server
cannot be connected.
Corrective action:
Perform the following procedures to correct the DNS address
in Internet protocol (TCP/IP) properties.
Right-click [My Network] and click [Properties].
Cause and corrective action
1. Start SNTP server operation on another machine.
Assume that the SNTP server address is
<172.22.78.246>.
2. Enter the following at a command prompt.
net time /setsntp:172.22.78.246
w32tm -s 172.22.78.246
1. Right-click [Local Area Connection] and click
[Properties].
2. Click [Internet Protocol (TCP/IP)] and click
[Properties].
3. Enter the correct DNS address in the [Primary DNS
server] box.