Updating Lan Drivers - Fujitsu Primergy RX100 S2 User Manual

• When a recognized network adapter is present
■
Perform "
adapters], then "
devices].
When the LAN driver is installed to [Other devices] before updating the driver for
the network adapter recognized immediately after the OS installation
When driver installation starts, the following window appears.
Clicking [Finish] displays the [Help and Support Center] window. Click [X] to close the window.
After installation, the "!" mark is displayed at the LAN device name in Device Manager. Device
names are displayed properly when all LAN drivers are installed and the system is restarted.
• When a recognized network adapter is not present
■
Perform "
devices].

■ Updating LAN Drivers

Perform the following procedures on all LAN device names under [Network adapters] in [Device
Manager].
1
Double-click a LAN device name under [Network adapters].
Names of the LAN devices are displayed as follows.
PG-1852
PG-1862
2
Insert the driver disk created from the ServerStart CD-ROM into the server
according to the installed LAN device.
3
Double-click the LAN device icon.
The properties are displayed.
Updating LAN Drivers" ( pg.121) on the LAN device name under [Network
■
Installing the LAN Driver" ( pg.122) on [Ethernet controller] under [Other
Installing the LAN Driver" ( pg.122) on [Ethernet controller] under [Other
table: LAN device name
LAN cards
Intel(R) PRO/1000 MT Desktop Adapter
Intel(R) PRO/1000 MT Dual Port Server Adapter
PRIMERGY RX100 S2 User's Guide
LAN device name
1
2
3
4
5
6
7
8
9
121