Altronix eFlow6NV Installation Manual page 9

Fig. 8 - eFlow6NXV configuration
Door
Wire Strap
(from
Enclosure
to Door)
CAUTION: When power supply board is set for 12VDC use only one (1) 12VDC
stand-by battery.
Keep power-limited wiring separate from non power-limited. Use minimum 0.25" spacing.
12AH Rechargeable batteries are the largest batteries that can fit in this enclosure.
An external battery enclosure must be used if using the 40AH or 65AH batteries.
eFlow6NV Series
RESET TRIGGER EOL
– AUX + disable 2 hr.
GND NO SUPERVISED
1 min.
enable
O
N
Battery
connections
OFF --- 24V
ON --- 12V
PD8/PD8CB
DC Output to devices*
(refer to Fig. 3a, 3b
for board configuration pg. 6)
Optional Rechargeable
Stand-by Battery
Battery and
220VAC
AC Supervision
power mains
Circuit
Green
Lead
(ground)
AC FAIL
BAT FAIL
Switch Detail
Switch On - 12V
Switch Off - 24V
PD8/PD8CB
DC Output to devices*
(refer to Fig. 3a, 3b
for board configuration pg. 6)
Sentrol
model # 3012
Tamper Switch
or equivalent
(Not Included)
5A 250V
Optional Rechargeable
Stand-by Battery
Edge of
Enclosure
Enclosure
to Access Control
Panel or
U.L. Listed
Reporting
Device
- 9 -