Table of Contents
Advertisement
SC-F7100 Series/SC-F7000 Series
I
Lower the roll onto the roll support.
Media Loading (SC-F7000 Series)
The Auto Take-up Reel Unit automatically takes up
media as it is printed, improving the efficiency of
unmanned operation.
The Auto Take-up Reel Unit for this printer can take up
media in either of the following directions.
Printed side out
Taking-up with printed side out places the printed
surface on the outside of the roll.
Taking-up with printed side in places the printed
surface on the inside of the roll.
!
Caution:
❏ Be sure that your hands or hair do not get
caught in the Auto Take-up Reel Unit while it
is in operation.
Failure to observe this precaution could result
in injury.
❏ Perform the following procedure to correctly
secure the roll core for the Auto Take-up Reel
Unit into place.
Injury may occur if the take-up roll falls.
User's Guide
Basic Operations
Printed side in
50
c
Important:
❏ Do not use a roll core with a deformed interior.
If the roll core holder slips, the media may be
taken up incorrectly.
❏ We recommend using a take-up roll core with
the same width as the media. If a take-up roll
core of a different width is used, the take-up
roll core may bend, and the media will be taken
up incorrectly.
Attaching the roll core
A
After confirming that the media is loaded
correctly, press the d button to feed the media as
far as the Auto Take-up Reel Unit roll core
holder.
c
Important:
Always press the d button to feed the media
as far as the roll core holder. If the media is
pulled by hand, the media may twist during
take-up.
Advertisement
Table of Contents
