GMC 1976 ZEO 6083 Maintenance Manual page 837

24P- 2 EXHAUST VENTS
MOTOR REPLACEMENT
(POWER VENTS) (FIGURE 2)
REMOVAL
Figure 1-Range Power Vent
1 . Remove vent crank handles (one screw each).
2. Remove vent screen (six screws).
3. Disconnect motor wires from switch and sup-
port .
4. Remove nuts retaining motor and switch to
vent housing.
5. Remove fan from motor.
CEILING VENTS
2. Connect motor wire to switch wire.
3. Install motor and mount assembly to vent
housing and secure with two nuts .
4. Position exhaust hood bottom assembly to bot-
tom of exhaust hood and secure with retaining nuts
at switches .
RANGE/OVEN VENT FILTER
(SEE FIGURE 1)
It is important that the power range hood filter
be inspected frequently and cleaned as needed . To
clean filter, remove retaining nuts at power hood
switches, remove filter and wash in hot, soapy water.
Rinse thoroughly and reinstall.
INSTALLATION
1 . Install fan on motor.
2. Position motor and switch in vent housing and
secure with retaining nuts .
3. Connect 12-volt motor wires to switch and
support.
VENT SCREEN REPLACEMENT
(FIGURES 2 AND 3)
REMOVAL
1 . Remove vent crank handles (one screw each).