Special Tools - GMC 1976 ZEO 6083 Maintenance Manual

1- 28 BODY
NOTE :
It may be necessary to remove interior
trim at rear of Motor Home to gain access to
license plate wiring connector.
2. Remove screws from interior trim to end cap.
3. Remove end cap to body retaining screws (32)
from end cap (See figure 43).
4 . Remove end cap from body .
SPECIAL TOOLS
J-2189-02
INSTALLATION
1 . Check seal to make sure it is still intact . Re-
place seal, if necessary.
2. Position end cap in place and install 32 retain-
ing screws .
NOTE:
The seven lower screws are self-tapping
screws while the 25 screws on the sides and top
of the end cap are hi-low screws .
3. Install screws retaining interior trim to end
cap.
4. Reconnect license plate wiring .
Glass Installing Tool