GMC 1976 ZEO 6083 Maintenance Manual page 35

1- 1 8 BODY
Figure 30-Entrance Door Adjustment-Horizontal
DOOR INSTALLATION
1. Install door .
2 . Install four (4) bolts, torque to 25-30 ft. lbs.
3. Check for leaks and correct as necessary .
Figure 31-Door Lock
ENTRANCE DOOR LOCK
REMOVAL (FIGURE 31)
1 . Remove lower door trim panel.
2. Remove lock button .
3 . Remove lower window moulding .
4. Remove upper trim panel and inner handle
assembly by loosening screws shown in Figure 32
and removing all other screws . Use care when
removing panel to avoid damaging door handle
mechanism .
5. Remove cotter pin from handle control rod.
Slide rod out of lever at lock mechanism.
6. Remove actuator lever pin and lock button rod
clip . See Figure 33 .
7. Remove (2) screws from latch assembly at
door frame. Remove this portion from the door .
8. Remove four (4) nuts and lock tumbler clip .
Remove lock mechanism. See Figure 33 .
INSTALLATION
1. Check sealer around lock opening in door,
replace or fill in as required to insure proper seal
between lock assembly and door.
Figure 32-Removing Trim Panels