GMC 1976 ZEO 6083 Maintenance Manual page 24

Figure 4-Removing Window Trim Moulding Screws
passenger area) will require interior trim panel re-
moval.
2. All sash assemblies are mounted as typically
shown in Figure 5. Remove retainers.
3 . Tap on the inside channel using a wooden
block and rubber mallet .
Figure 5-Removing Sash Retainers
BODY 1- 7
NOTE:
The sash assemblies are heavy. Have
someone assist by supporting the assembly from
the outside .
4. Remove sash assembly .
5. Remove filler seal from sash assembly.
Installation
1 . Apply a new filler seal to the sash assembly .
2. Install sash assembly . Position spacers as
shown in Figure 6.
NOTE : Late model vehicles are not equipped
with spacers (figure 6) . A 3/16 inch gap should
be maintained between sill and sash .
3 . Install retainers.
4. Install panels if removed and install trim
mouldings.
GLASS
Removal
1 . Remove sash assembly . Refer to "Sash Assem-
bly - Removal" earlier in this section.
2 . Remove the banding strap, if equipped, as
shown in figure 7, then disassemble sash assembly as
shown in Figure 8.
3 . Remove glass .
Figure 6-Sash Spacers