GMC 1976 ZEO 6083 Maintenance Manual page 158

Figure 13-Installing Balls in Outer Race
NOTE:
If a brass drift is used to install the sixth
ball, make certain metallic chips from drift do
not enter assembly .
5. Pack C.V. joint full of Lubricant No . 1050802
or equivalent .
6. Pack inside of seal with Lubricant No .
1050802 or equivalent until folds of seal are full .
7. Place service clamp on axle shaft. Two wraps
of band are required .
8. Install seal onto axle shaft.
9. Install retaining ring into inner race with tangs
protruding into relieved area . (figure 16)
POSITION LIP
OF
SEAL IN
GROOVE
OF
OUTER RACE
CLAMP
AX LE
GROOVE
IDO NOT
USE)
Figure 14-Positioning Seal
DRIVE AXLES 3131- 7
Figure 15-Assembly of J-22716 to Band
10 . Insert axle shaft into splines of outer C .V .
joint until retaining ring secures shaft in second snap
ring groove .
11 . Position seal in groove of outer race . (figure
12 . Position small end of seal in nearest joint
groove on axle shaft. (figure 14)
NOTE:
After seal is in position on axle shaft
make sure no lubricant is in grooves of seal
before installing seal clamp band .
13 . With service clamps over seals in correct posi-
tion, follow procedures listed below.
a. Pull clamp to desired size and insert band
into Tool J-22716. Then insert nut into tool with
band in slot of nut as shown in Figure 15 .
Figure 16-Tightening Band