GMC 1976 ZEO 6083 Maintenance Manual page 738

24D- 8 REFRIGERATOR
3 . Disconnect wiring from back of assembly (fig-
ure 17).
DOOR PANEL REMOVAL
1. Remove door(s) and place door on flat surface
liner side down.
2. Remove bottom frame member by removing
three screws, as shown in Figure 18 .
3. Loosen three screws on both side frame mem-
bers .
Figure 19-Removing Trirp Panel
4. Trim panel can now be removed by sliding it
2. Remove screw at front of inverter assembly out the bottom (figure 19).
mounting plate (figure 16). Lift assembly out of re-
frigerator .
DOOR INSTALLATION
2. Place inverter assembly in position and secure
with screw at mounting plate, as shown in Figure 16 .
1 . Place lower door on bottom hinge pin and
push door to its normal position .
3. Install kick plate.
2 . Install center hinge pin (figure 9) .
COMPONENT INSTALLATION
3 . Place freezer door on its lower hinge pin and
COOLING UNIT INSTALLATION
push door to its normal position.
1 . Through opening in back of refrigerator posi-
4. Install top hinge pin and secure travel lock .
tion evaporator plates in cabinet.
THERMOSTAT INSTALLATION
2. Install mounting screws in compressor.
3. Install blind cover in rear opening (See figure
15). Tape in place.
1 . Install face plate to thermostat with two nuts
and bolts. 4 . Install sheet metal plate over rear opening (fig-
ure 13).
2. Install three electrical leads shown in Figure
10. 5. Install eight mounting screws in condenser.
3. Install sensing tube to freezer tray . 6 . Apply sealer (non-hardening caulking) to seal
hole where capillary and return tubes pass through.
4. Position thermostat on cabinet wall and secure
with four screws .
5. Install control knob .
INVERTER ASSEMBLY
INSTALLATION
7. Connect electrical leads to compressor .
8. Install thermostat sensing tube to bottom of
lower evaporator plate.
9. Secure evaporators with eight screws (figure
11).
1 . Connect wiring as shown in Figure 17 . 10 . Install refrigerator in MotorHome.