Disc Hub Assembly; Disc; Knuckle Seal; Knuckle - GMC 1976 ZEO 6083 Maintenance Manual

REMOVAL (FIGURE 10)
1 . Remove disc and hub assembly . Refer to DISC
AND HUB ASSEMBLY-Removal .
2. Remove hub bearing. Refer HUB BEARING-
Removal.
3 . Remove (4) bolts and seperate disc from hub
as shown in Figure 10.
INSTALLATION
lbs.
DISC
1 . Install four attaching bolts and torque to 35 ft.
2. Install hub bearing. Refer HUB BEARING-
Installation .
3 . Install disc and hub assembly . Refer DISC and
HUB ASSEMBLY-Installation.
REMOVAL
KNUCKLE SEAL
1 . Remove disc and hub (See DISC AND HUB
REMOVAL, Section 3A).
2. Pry seal from knuckle .
INSTALLATION
1 . Place knuckle seal on Tool J-26485 . Insert tool
Figure 1 0-Disc Removal
FRONT SUSPENSION
3A- 11
Figure 1 1-Installing Bearing
as far as possible into knuckle and then drive it in
with a hammer until it bottoms (figure 12). Remove
tool .
2. Install disc and hub (See DISC AND HUB
INSTALLATION, Section 3A).
REMOVAL
KNUCKLE
1 . Remove disc hub assembly (refer to DISC
HUB ASSEMBLY, REMOVAL).
Figure 12-Installing Knuckle Seal