GMC 1976 ZEO 6083 Maintenance Manual page 823

24K- 4 TOILET
TOILET INSTALLATION
1 . Install a new flange seal over mechanism ring
found on underside of toilet .
2. Set toilet in place and install rear mounting nut
using the 12" extension and universal socket with a
small amount of grease in the socket to hold the nut
in place.
3 . Tighten rear mounting nut.
4. Depress toilet pedal and insert block of wood
in slide trap to keep the trap open . This holds the
pedal down for access to front mounting bolt . Install
nut and tighten.
The optional recirculating toilet operates by
recirculating the liquid present in the toilet and a
5. Depress pedal and remove block of wood .
6. Connect toilet water line .
MAINTENANCE
No routine maintenance is required .
If the bowl sealing blade does not operate freely
after extended use, it may be restored to its original,
smooth operating condition by applying a light film
of Silicone spray to the blade.
To clean the toilet, use any high grade, non-abra-
sive cleaner . Do not use highly concentrated or high
acid content household cleaners . They may damage
the rubber seals .
RECIRCULATING TOILET (ELECTRA-MAGIC)
GENERAL INFORMATION
chemical additive . The advantage is that water is
conserved when flushing and also not adding to the
volumn of the holding tank . The toilet operates on
12-volt DC .
RECIRCULATING TOILET TROUBLE DIAGNOSIS
Complaint Possible Cause
Correction
1 . Toilet will not flush. a. Blown living area fuse .
a. Replace blown fuse in living
area electrical compartment.
b. Blown toilet fuse . b . Replace toilet fuse under toilet
motor cover.
c. Pump motor defective. c. Replace pump assembly .
d. Damaged timer. d. Replace timer assembly .
2. Toilet does not cycle a. Source of power less a. Check batteries or power
properly (5 to 9 than 12-volts . converter.
seconds) when button is
pressed .
- - b. Damaged timer.
b . Replace timer assembly .
3. Toilet cycles when a. Actuator button pro-
a. Alternately press one side of the
seat cover is raised . trudes too far from
button, then the other, to work the
motor cover.
button back further into the
housing. If button still protrudes
too far, replace timer assembly .
4. Flushing action is a. Unit cycling without
a. Charge unit with water to the
weak or noisy. adequate water charge .
proper level.
b. Source of power less b. Check batteries or power
than 12-volts .
converter.
c. Pump damaged by con- c. Replace pump assembly .
tinuous dry operation.