GMC 1976 ZEO 6083 Maintenance Manual page 789

24H- 10
RANGE/OVEN
7. Remount unit from cabinet module.
8. To install unit reverse the above procedure.
OVEN DOOR HINGE REPLACEMENT
1 . Remove range/oven unit from cabinet module
(See "Range/Oven Unit Replacement") .
2. Remove side trim (Items 21 and 36, figure 5)
to avoid damage while servicing hinge.
3 . At this point door hinge and spring is accessi-
ble for servicing, as necessary.
GENERAL
Regular cleaning with warm detergent solution
and a soft cloth will keep your range looking bright
and new. This should be done as soon as range cools.
Porcelain Enamel- Wipe surface clean immedi-
ately. Do not use metal scouring pads or cleanser
containing grit or acid .
Chrome - To keep the mirror-bright finish,
wipe with damp cloth and dry thoroughly . Stubborn
stains may be removed with lemon juice, vinegar or
chrome polish .
Glass - Wipe cooled glass with detergent and
hot water. Rinse and polish with soft cloth .
BROILER PAN
Remove from oven immediately after use. Drain
fat. Sprinkle rack with detergent and cover with wet
paper towels and let soak, before washing in hot
soapy water.
PILOT ADJUSTMENT
The oven pilot is preadjusted and cannot be ad-
justed .
The range burner pilot (if so equipped) should
burn with a blue flame having a slight yellow tip. The
CARE AND CLEANING
4. To install reverse above procedure.
OVEN DOOR GLASS REPLACEMENT
1. Remove oven door from range/oven unit (See
"Oven Door Replacement").
2. Referring to Figure 5, carefully disassemble
door.
3 . With oven door disassembled replace glass
(Items 25 or 28, figure 5) .
4. Install oven door glass by reversing the above
procedure.
OVEN
Clean as soon as possible after use and when the
oven is cool . Grease splatters that are allowed to
become hard and baked on are very difficult to
remove.
Care must be taken to avoid bending the tube
clipped to the top of the oven . This is the thermal
sensing element and could cause a variation between
the oven temperature and dial setting.
If oven cleaners are used, be sure to rinse the tube
thoroughly and wipe dry.
TOP BURNERS
Top burners may be cleaned with a detergent
solution. If any burner port should become clogged,
clean with a toothpick . Never use pins or other metal
objects to clean the ports, as they may become en-
larged . If the burner is washed in a sink, dry immedi-
ately by shaking off all excess water and lighting the
burner until all water has evaporated .
ON-VEHICLE ADJUSTMENTS
tip of the flame should extend to approximately the
top of the lighter body . The adjustment screw is
located behind the range pilot shut off valve pilot
remove dial and insert small screwdriver through the
hole (figure 25). Rotate adjustment screw as re-
quired .