GMC 1976 ZEO 6083 Maintenance Manual page 296

Figure 12-Air Conditioning Compressor Mounting
6. Install PCV valve into grommet on R.H . valve
cover.
7. Connect vacuum lines to the distributor and
tee as shown in Figure 14 . Connect vacuum line to
front of carburetor (from the carbon canister). Con
nect to the intake manifold vacuum lines, to the
brake booster, heater control and cruise control (if
equipped). See Figure 13 .
8 . Connect throttle cable, and cruise control (if
equipped). See Figure 13 .
9. Install fuel line .
10 . Connect temperature gauge wire .
11 . Install air conditioning bracket (if equipped).
See Figure 12 .
12 . Install oil fill tube and flexible elbow.
Figure 13-Location for Disconnecting
Vacuum Hoses and Throttle Cable
ENGINE 6A- 3 1
ies .
Figure 14-Distributor and Transmission Vacuum
Lines (Typical)
13 . Install generator
mounting bracket,
if
removed. See Figure 11 .
14 . Adjust belt tension. Refer to "Belt Tension"
later in this section.
15 . Install venturi ring brace(s) . See Figure 10.
16 . Connect upper radiator hose, thermostat and
by-pass hose to the water outlet . Connect heater hose
at rear of manifold .
17 . Install air cleaner.
18 . Connect battery negative cables to the batter-
19 . Fill radiator . Start engine and check for leaks.
COAT BOTH S IDES OF
INTAKE MANIFOLD
GASKET AT THE SEALING
AREA WITH 1050026 SEALER
OR EQUIVALENT
Figure 15-Intake Manifold Gasket