GMC 1976 ZEO 6083 Maintenance Manual page 167

3C- 4
FINAL DRIVE
Figure 4-R.H . Output Shaft Attachment
5. Remove output shaft assembly .
6. If output shaft seal is to be replaced, install Seal
Remover J-23129 into seal and drive seal out with a
hammer . (figure 5)
7. If output shaft bearing is to be replaced, it can
be removed with a press as shown in Figure 6.
INSTALLATION
See CAUTION on Page 3C-1 of this section .
Figure 5-Removing R.H . Output Shaft Seal
Figure 6-Removing R.H . Output Shaft Bearing
1 . If output shaft bearing was removed, assemble
parts as shown in Figure 7.
2. Position assembly in a press and install bearing
until seated as shown in Figure 8.
3. Pack area between bearing and retainer with
wheel bearing grease, then install slinger as shown in
Figure 9.
FILL INDICATED
AREAS WITH
WHEEL BEAR I NG
GREASE
Aeo
RETAINER
Figure 7-R.H . Output Shaft Assembly