GMC 1976 ZEO 6083 Maintenance Manual page 138

5. Remove seal and retainer .
6. Clean bearing and inspect for wear or damage.
If bearing condition is good repack with bearing
grease . Use GM part No. 1051344 or equivalent, a
premium high melting point lubricant .
INSTALLATION
See CAUTION on Page 3A-1 of this section.
Figure 6-Disc and Hub Assembly
1 . Position retainer over hub.
FRONT SUSPENSION 3A- 9
RETAINER TO
KNUCKLE BOLT
HUB CAP
RETAINER
WHEEL STUD
BEARING ASSEMBLY
2. Lubricate seal lips with Special Seal Lubricant
No. 1050169 or equivalent then position seal over
hub with metal end toward retainer .
3 . Install bearing as shown in Figure 11 .
4. Install disc hub assembly. Refer to DISC AND
HUB ASSEMBLY- Installation .