Installing The Short-Term Battery Box In The 19" Chassis-A - NEC UX5000 Hardware Manual

Chapter 1 - Installing the Chassis
1.6.1.2

Installing the Short-Term Battery Box in the 19" Chassis-A

1.
2.
3.
4.
5.
6.
7.
1 - 20
●
Though the battery cage is provided standard as part of the Chassis-A, the batteries are
optional equipment.
Make sure the chassis is powered off and unplugged.
On the back of the 19" Chassis-A, remove the 2 screws holding in the metal plate on the left
side of the chassis.
Remove screws to install
Figure 1-24: REMOVE SCREWS ON 19" CHASSIS-A
Remove the screw holding in the fan's metal plate. Remove the cover by lifting it on the left
side and sliding it slightly to the right.
●
Use caution when removing the plate as the fan is attached to this plate but it is still
plugged into the connection on the chassis.
On the battery box cage, remove the screws holding down the 2 brackets on the top of the
box.
Install the 2 battery units (2.3AH-12V batteries) into the battery box cage. and reattach the 2
brackets to secure the batteries in place.
Provided with the battery box are 2 cables. Clip the short wire to the batteries at the front.
Figure 1-25: BATTERY BOX WITH BATTERIES AND CABLES
With the long 2-wire cable, clip each end to the batteries at the back.
Chapter 1