NEC UX5000 Hardware Manual page 37

Chapter 1 - Installing the Chassis
15. Looking at the back of the battery box, the cables should be connected sequentially to the
chassis going from right to left. Take the cable on the farthest right and connect it to the first
system chassis. Continue for any remaining system chassis.
Connect to the system chassis by removing the screw for the fan panel on the back of the
chassis. Plug the cable from the battery box into the connect labeled BATT. Replace the cover,
feeding the battery cable out the key hole opening in the panel.
Figure 1-37: CONNECT BATTERY BOX CABLE TO CHASSIS
Expansion Base
Chassis Chassis
Two Chassis Share
Battery Back-Up
Connection
to Chassis
Right to Left
Connection to
Chassis
First Connection
to Base, Then Expansion
Figure 1-38: CONNECTION FROM BATTERY BOX TO CHASSIS
Chapter 1 1 - 27