Table of Contents
Advertisement
4.
Remove the connector board cable (see
Remove the connector board:
1.
Remove the two Phillips M2.0 × 2.9 screws (1) that secure the connector board to the computer.
2.
Remove the connector board (2) from the computer.
To replace the connector board, reverse the removal procedures.
Fan
To remove the fan, use these procedures and illustrations.
Table 5-8
Fan description and part number
Description
Fan (includes fan cable)
Before removing the fan, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the computer (see
Remove the fan:
1.
Disconnect the fan cable (1) from the system board.
2.
Release the display panel cable from the retention clips (2) that are built into the fan.
3.
Remove the four Philllips M2.0 × 3.3 screws (3) that secure the fan to the computer.
Connector board cable on page
Preparation for disassembly on page
Bottom cover on page
33).
Battery on page
41).
Spare part number
N94801-001
33).
35).
Fan
43
Advertisement
Table of Contents
