Table of Contents
Advertisement
TERMINALS
ON CONTROL
Long-Range Radio Connections
If output to Long-Range Radio (LRR) is selected, all
messages that are programmed to go to the primary
telephone line receiver are also sent to any LRR that
can operate in ECP mode.
Wiring Connections
Connect the data in/data out terminals and voltage input
terminals of the Long Range Radio to the control's keypad
connection points, terminals.
For complete information, see the manual that
accompanies the radio.
NOTES:
• Use 7720PLUS, 7820, or 7835C Long Range Radios
• Messages are sent in Contact ID
affected by entry in field 46).
You must enable field
RANGE RADIO, if this feature is to function.
For UL installations, Long-Range Radio must be
U L
disabled ( 27 = 0).
INCOMING
TELECOM
HANDSET
LINE
17
18
19
20
Figure 2-12. Standard Telephone Line Connections
®
format (not
27, OUTPUT TO LONG-
Section 2 – Installing the Control & Peripherals
21
EARTH GROUND
PLUG
RJ31X
JACK
DIRECT
CONNECT
CORD
The VISTA-10SE control panel features Dynamic
Signaling Delay (DSD) and Dynamic Signaling Priority
(DSP) message reporting when Long-Range Radio is
used. Refer to field 93 in SECTION 4: Data Field
Programming for further details.
Audio Alarm Verification (AAV) Connections
Wiring Connections
Refer to the connection diagrams below. Figure 2-13
shows connections when a 4285/4286 VIP (Phone)
Module is not used, Figure 2-14 shows connections
when the 4285/4286 is used.
The AAV option cannot be used in UL
U L
installations.
NOTES:
• Suggested AAV Module: Eagle 1250
• To enable the AAV feature, enter option "4" in field 91
Option Selection (AAV)
• Select Contact ID
number
• Program alarm reports for the primary phone number.
• You must connect a 4204 relay module when using
an AAV unit, as shown in the following diagrams.
INCOMING TELECOM LINE
TIP
PREMISES
RING
PHONES
V10SE-024-V0
®
report format to primary phone
2-11
Advertisement
Table of Contents
