Winding A Bobbin - Bernina 580 Manual

Sewing preparation
14

Winding a bobbin

turn power switch to «I» (on)
█
place empty bobbin on spindle
█
place foam pad on the spool pin
█
place thread on the spool pin
█
attach appropriate spool disc
█
following the direction of the arrow, take the thread through the rear guide
█
and round the pre-tension stud
A
wind the thread two to three times around the empty bobbin
█
cut off any excess thread on the thread cutter A
█
Appropriate spool disc
Diameter of thread spool determines disc size. There must be no
gap between the disc and the spool.
push engaging lever A against bobbin
█
►
the winder works automatically
►
the Display to wind the bobbin is opened
move the round knob in the Display to the left/right or
█
turn the stitch width knob (see page 10)
A
█
►
the winding speed is altered
►
the motor will stop automatically when the bobbin is full
►
the Display is closed
remove bobbin and
█
pull the thread over thread cutter A to cut it
█
B
Bobbin winding while sewing
attach foam pad on the vertical spool pin B
█
place thread on the vertical spool pin
█
following the direction of the arrow, take the thread through the thread
C
█
guide C and
guide around the pre-tension stud
█
Then proceed as mentioned above.
It is recommended to reduce the winding speed when winding from
the vertical spool pin.
033527.53.04_2014-07_Manual_B580_EN