Exchanging Bobbin Case - Bernina 580 Manual

Inserting a bobbin/Threading lower thread
A

Exchanging bobbin case

insert the bobbin so that the thread runs clockwise A
█
pull the thread from the right into the slot
█
pull the thread to the left under the spring
█
until it lies in the T-shaped slit at the end of the spring
█
pull the thread
█
►
the bobbin must turn clockwise
Removing the bobbin case
raise the needle
█
turn power switch to «0» (off)
█
open bobbin cover
█
grasp the latch of the bobbin case
█
remove the bobbin case
█
Inserting the bobbin case
hold the bobbin case latch
█
Opening of the bobbin case points up.
insert the case so that it clicks into place
█
Bobbin thread cutter
pull the thread over thread cutter A to cut it
█
A
close the cover
█
033527.53.04_2014-07_Manual_B580_EN
Sewing preparation
15