Thread breakage when embroidering
Upper or lower thread breaks
Embroidery sequence control when thread breaks
The upper or lower thread may occasionally run out or break when you are
embroidering. When this happens, the embroidery computer stops
automatically, provided that the thread and bobbin indicators are activated in
the setup program.
►
the embroidery computer stops automatically
►
an animation is displayed
check upper thread
█
rethread needle
█
check lower thread
█
refill or rethread bobbin
█
touch «Thread breakage»-icon
█
In the left portion of the Display the motif is shown in original size and in the
right protion enlarged. This makes it easier to check the embroidery sequence.
►
the message to operate the stitch width and stitch length knobs appears
turn the knobs to the left or to the right
█
►
the hoop moves along the embroidery sequence backwards or forwards
turn the stitch width knob slowly
█
►
the hoop is moved stitch by stitch
turn the stitch length knob slowly
█
►
the hoop is moved in big steps
►
the number in the yellow-framed icon indicates the current position within
the motif by stitch number
via the «0-9»-icon a position can be entered directly
█
position the needle back far enough so that it will resume stitching several
█
stitches before the thread breakage
Returning to original position
touch «Back»-icon
█
►
the Display is closed
Resuming embroidering
press «Start/Stop»-button or the foot control
█
033527.53.04_2014-07_Manual_B580_EN
Motif
157