Sewing Preparation; Foot Control - Bernina 580 Manual

Sewing preparation

12
Power Switch/Power Cable
6
5
4
3

Foot control

Slide-on table
1 Power Switch
The sewing computer is switched on («I») and off («0») with the power switch.
1
2 I
0 the sewing computer is switched off
2 Power plug socket
3 Foot control socket
4 Connection for embroidery module
5 PC-connection for embroidery software
6 USB-connection
Before beginning to sew
█
█
A
█
Sewing speed control
Control the sewing speed by pressing the foot control more or less.
B
Adjust needle down or up
█
D C
After sewing
█
█
1
█
►
█
►
The slide-on table increases sewing surface.
Attaching the slide-on table
█
A █
Removing the slide-on table
█
█
█
033527.53.04_2014-07_Manual_B580_EN
the sewing computer is switched on
unwind the cable
plug the cable in the outlet provided A
unwind the cable to the desired length and slip into B or C
adjust the down/up position of the needle by sinking the heel back on the
foot control
wind the cable around the reel
plug cable into D
USA/Canada only: Use only foot controller type LV-1 with
sewing computer B 580.
turn the handwheel (see page 11)
needle is raised
raise presser foot lifter 1 up
presser foot is lifted
raise the needle and presser foot
slide over free-arm to the right until it engages
raise the needle and presser foot
press button A down
pull slide-on table to the left