Starter Solenoid Bench Test; Starter Solenoid Operation - Polaris 2009 Ranger RZR 800 EFI Manual

2. Remove the retaining ring, thrust washer, spring retainers
and clutch return spring. Screw the overrun clutch off the
end of the pinion shaft. Remove the old spring and install
a new one. Lightly grease the pinion shaft and reinstall the
clutch, spring, retainers, end washer and lock ring in the
reverse order. Make sure the end washer is positioned
properly so that it will hold the lock ring in its groove.

Starter Solenoid Bench Test

Test the start solenoid by powering the solenoid via the 2-wire
connection. With the solenoid energized, resistance should read
about 0.5Ω ± 10% between terminal (A) and (B). If resistance
measurement is out of specification, replace the starter solenoid.
A

Starter Solenoid Operation

To energize the Starter Solenoid the following must occur:
• The brake must be applied to provide a ground path via
the Orange wire.
• The key switch must be turned to the "start" position to
provide 12V power via the White / Red wire.
• Once the pull-in coil is energized, the solenoid provides
a current path for 12V power to reach the starter motor.
Energize
Here
B
ELECTRICAL
10
10.29