Polaris 2009 Ranger RZR 800 EFI Manual page 27

4. Inspect the main air filter element and replace if necessary.
Do not clean the main filter, the filter should be replaced.
NOTE: If the filter has been soaked with fuel or oil it
must be replaced.
5. Wash pre-filter in warm soapy water and allow it to air dry.
NOTE: If unable to clean the pre-filter, replace it.
Seal
Air Filter
NOTE: Service more frequently if vehicle is operated
in wet conditions or at high throttle openings for
extended periods.
Air Intake Duct
Foil
Breather
Hose
T-MAP
Sensor
Fitting
Boot
Clamps
Cap
Pre-Filter
Sleeve
Intake Box
Seal
Breather
Filter
Clip (3)
Air Box Can
Installation
1. Clean the air box thoroughly.
2. Install a new or clean pre-filter over the main air filter
element.
3. Place filter ring over the end of the filter and install the filter
into the air box. Be sure the filter fits tightly in the air box.
NOTE: Apply a small amount of general purpose
grease to the sealing edges of the filter and the air
box cap seal before installing.
4. Install air box cap and secure with clips.
Secure Clips
Front
Foam Seal
Primary
Foam Seal
Air Filter
Filter Ring
MAINTENANCE
Intake Seal
Cap
Pre-Filter
Seal
Sleeve
2.15
2