FINAL DRIVE
Drive Shaft Exploded View
REAR SHAFT
RZR "S" SHAFT
Spring Ring
Spring Ring
Large Clamp
Grease Pack
Small Clamp
Wheel Side
Grease Pack
Large Clamp
Spring Ring
7.32
RZR SHAFT
Plunging
Joint
Gear Side
Boot Kit
Boot Kit
CV Joint
Installation
1.
Install new spring ring on drive shaft. Apply anti-seize
compound to splines.
2.
Align splines of drive shaft with rear gearcase and reinstall
the drive shaft. Use a rubber mallet to tap on the outboard
end of the drive shaft if necessary.
NOTE: Take care when installing the drive shaft to
prevent damaging the seal.
3.
Slide the rear drive shaft into the rear bearing carrier.
NEW
Spring Ring
Apply
Anti-Seize