Bottom-End Disassembly; Starter Drive Gear Removal And Inspection - Polaris RANGER RZR 170 Service Manual

3. If the installed gap measurement exceeds the limit,
replace the rings. If using new rings and the
measurement is too small, file the ring ends to achieve
the proper gap.
NOTE: Always check piston ring installed gap after
re-boring a cylinder or when installing new rings. A
re-bored cylinder should always be scrubbed
thoroughly with hot soapy water, rinsed, and dried
completely. Wipe cylinder bore with an oil rag
immediately to remove residue and prevent rust.

BOTTOM-END DISASSEMBLY

Starter Drive Gear Removal and Inspection

1. Remove the fan from the hub.
2. Remove the fan hub by removing the flywheel nut,
washer and pulling the hub from the crankshaft.
3. Remove stator housing bolts and remove housing.
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
ENGINE
Washer
Flywheel Nut
3.27
3