Contura C 460 Installation Instruction page 19

Use the adhesive to fill the gaps between the different sections of
the chimney hood, adding pieces of fibre-glass tape to reinforce
the seal. The adhesive should also be used to fill the gap between
the hood and the marble slabs of the shelf. The gap between
the concrete surround and the marble shelf is filled with acrylic
sealant.
Fill the gaps between the concrete surround and the wall-
protection panels, and those between the metal profiles of the
wall-protection panels with acrylic sealant. Before starting this
work, clean the profiles with mineral spirits or a similar kind of
solvent.
When the cement and the acrylic sealant have dried, paint the
entire concrete surround and the wall-protection panels with a
textured coating. Allow the paint to dry for 24 hours and then
go over the painted areas with a latex paint (gloss 07). Take
precautions to protect the stove body against paint splashes.
The grilles are simply placed loose over the air vents. Before fitting
the metal floor-plate (optional accessory) around the stove plinth,
cut away the inside section and smooth off any jagged edges or
burrs. The marble floor slab (optional accessory) may simply be laid
loose around the plinth or cemented in place on the floor below
If you prefer, you can fit the special niche cover to conceal the
niche. Fit the cover flush with the outer contours of the hood and
secure it with adhesive. Seal the gap around the cover with acrylic
sealant
!
Wait for the cement to dry for at
least one week before lighting a
fire in the stove.
GB
17