Contura C 460 Installation Instruction page 16

GB
14
Dab a few heaps of cement
on the mantelshelf and lift
the hood base into place.
!
Use silicone to attach the
cover to the rear wall.
Heat reflector
Screw the heat reflector into place on the sealing plate. Lay the
sealing plate in place inside the hood base and fix it to the rear
panel with screws.
If the stove is to be connected to a top flue, cut away the punched
cover. Insulate the sealing plate with the blocks of insulating
material supplied. For the low model, only one of the insulation
blocks is required.
Sealing plate
If you are installing the low 460 model, you can now fit the marble
top to the hood base using silicone.
!
In this instance it is extra important
to make sure that there is a tight
seal between the concrete surro und
and the rear panel as hot air will be
collecte d in this cavity.